| Tweet |
Custom Search
|
|
|
||
 Bleed Air From the Governor
4.
Remove the drain plug. Allow oil to drain.
1.
Start the engine and allow the engine to reach
normal operating temperature.
5.
Clean and install the drain plug.
Loosen nut on the side of the governor which
2.
holds compensation adjusting pointer
6.
Fill the governor, with clean oil, to the FULL
mark on the dipstick. Refer to the Lubrication and
Manually move pointer to the extreme upper
3.
Maintenance Chart for proper oil.
position. Tighten nut This will allow the governor to be
purged of air.
7.
Connect the ground cable to the battery.
8.
Open the fuel tank supply valve.
9.
Use the procedure that follows to bleed the
governor.
619
|
||
|
||
