TM   5-2815-241-34&P AIR  COMPRESSOR  AND  FUEL  PUMP  INSTALLATION INITIAL   SETUP Tools Materials/Parts  -  Continued Extension,   6-inch,   1/2-inch   drive Handle, ratchet, 1/2-inch drive Socket,   9/16-inch,   1/2-inch   drive Wrench,   box-end,   half-moon,   5/8-inch Wrench,   open-end,   11/16-inch Wrench,  open-end,  l-inch Lockwasher,  air  compressor  bracket Lockwasher,  fuel  pump  to  air  compressor  (four required) Personnel   Required Two Materials/Parts Equipment   Condition Gasket,  air  compressor  to  accessory drive Gasket, air compressor to fuel pump Lockwasher,  air  compressor  to accessory drive (four required) Accessory   drive   installed   (page   2-84). ACTION LOCATION ITEM REMARKS 1.  Air  compressor  (1) 2. Fuel pump (3) Crankshaft   (2) New  gasket  (4)  and coupler  (5) 3.  Air  compressor  (1) 4. Fuel pump (3) Fuel  pump  (3) Two  nuts  (6)  two new  lockwashers  (7) and  two  flat washers  (8) 5. Two  screws  (9),  two new   lockwashers (10),  and  two flat  washers  (11) 6. Two  nuts  (6) 7. Air  compressor  (1) New  gasket  (12)  and coupling   (13) Rotate  to  position  part  numbers  stamped  on gear  towards  engine  (see  illustration). Put on gasket and aline couplers. Aline  and  put  together. Using   11/16-inch   open-end   wrench,   screw in until snug. Do  not  tighten. Using   5/8-inch   half-moon   box-end   wrench, screw  in  and  tighten. Using   11/16-inch   open-end   wrench, tighten. Put  on. 2-86