TM 5-2815-241-34&P
CYLINDER BLOCK - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
21. Cylinder block (7)
Cylinder sleeve (1)
a.
Install, without preformed packing,
packing, or gasket.
b.
Using thickness gage (8), check clear-
ance between cylinder sleeve (1) and
cylinder block (7). Clearance should be
0.002 inch (0.05 mm) to 0.006 inch
(0.15 mm).
Clearance less than 0.002 inch (0.05
mm) is permissible as long as any
cylinder sleeve to cylinder block
contact does not cause cylinder
sleeve to be out of round, step 22.
If clearance is greater than 0.008 inch
(0.15 mm), tag cylinder block for
cylinder sleeve lower bore repair
sleeve, steps 29 thru 35.
TA 242432
2-151
|
|