TM   5-2815-241-34&P CYLINDER  BLOCK  -  CONTINUED ACTION LOCATION ITEM REMARKS 36. Cylinder block (1) Main  bearing  cap  (5) Place  in  correct  position  in  cylinder  block. Main  bearing  caps  provide  a  0.0015  to 0.0045 inch (0.04 to 0.11 mm) inter- ference  fit  in  cylinder  block. NOTE Steps  34  thru  36  apply  to  replacing  the  number  7  main  bearing  cap. 37. 38. 39. 40. Locating   dowels   (6) Remove  from  block. Main  bearing  cap  (5) a.     Using  prussian  blue  on  block  surface, place main bearing cap in position, and locate dowel holes in main bearing cap. b.      Remove  main  bearing  cap. c.     Install dowels in cylinder block and re- install  main  bearing  cap. Install  all  caps  and  tag  cylinder  block  for main  bearing  bore  reaming,  steps  41 thru  50. Straight  pins  (7) a.    If nicked, using emery cloth remove all nicks. b.    If out of round, using pin puller, remove. c.    Using  plastic-faced  hammer,  install new  straight  pins. TA  242439 2-159