TM   5-2815-241-34&P PISTON AND CONNECTING ROD - CONTINUED ACTION LOCATION ITEM REMARKS 34. Bearing  cap  (4), two  bolts  (2), two  nuts  (5),  and two  washers  (6) Put on and torque nuts as specified in step 11. REPAIR NOTE Perform  steps  35,  36,  and  37  for  connecting  rods  tagged  for  milled  surface  repair. 35.  Connecting  rod  (1) Bearing  cap  (4), two  bolts  (2),  and two  nuts  (5) Using  1/2-inch  drive  15/16-inch  socket  and hinged handle, unscrew and take off. 36. Connecting  rod  (1) 37. a. Using  half-round  file,  file  milled  surface of connecting rod a maximum of 1/16 inch  (1.59  mm). b. Form a fillet radius (8) at ail corners where connecting rod (1) is milled for bolthead to a dimension of 0.045 to 0.055  inch  (1.14  to  1.40  mm). Fillet  radius  must  be  1/2  inch  (12.7 mm) in length or more. Blend radii at ends  of  cut. Bearing  cap  (4), two  bolts  (2),  two nuts  (5),  and  two washers   (6) Put on and torque nuts as specified in step 11. 2-231