TM  5-2815-241-34&P WATER  MANIFOLD  ASSEMBLY  REMOVAL INITIAL  SETUP Tools Wrench,   open-end,   9/16-inch ACTION LOCATION ITEM REMARKS 1. Rear and center Four  screws  (2)  and cylinder  heads  (1) four   lockwashers   (3) Using   9/16-inch   open-end   wrench,   un- screw and take out. Discard    lockwashers. 2. Four  screws  (4)  and four   lockwashers   (5) Using   9/16-inch   open-end   wrench,   un- screw and take out. Discard    lockwashers. 3. 4.  Front  cylinder head (8) 5. Water  manifold center and rear sections  (6)  and four  gaskets  (7) Carefully pull out and remove. Discard   gaskets. Two  screws  (9)  and two   lockwashers   (10) Using   9/16-inch   open-end   wrench,   un- screw and take out. Discard    lockwasher. Two  screws  (11)  and two   lockwashers   (12) Using   9/16-inch   open-end   wrench,   un- screw and take out. Discard   lo&washers. CAUTION Care must be taken not to damage connector tube. Connector tube remains with water manifold  front  section. 2-18