TM  5-2815-241-34&P TURBOCHARGER  -  CONTINUED ACTION LOCATION ITEM REMARKS DISASSEMBLY  - CONTINUED 13.  Bearing  housing  (1) Wheel  and  shaft  (2) Tap end of wheel and shaft lightly on work bench. Remove  wheel  and  shaft  from  bearing housing. 14. Wheel  and  shaft  (2) Two  sealing Take  off. rings  (3) Discard. 15.  Bearing  housing  (1) Heat  shield  (4)  and packing   (5) Oil control ring (7) Take  off. Discard   packing. 16.  Turbocharger sleeve  (6) Take  off. Discard. CLEANING WARNING Drycleaning solvent P-D-680 is toxic and flammable. Wear safety goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes, and do not breathe vapors. Do not use near open flame or excessive heat. Flashpoint for type  #1  drycleaning  solvent  is  100oF  (38°C)  and  for  type  #2  is  138°F  (59°C).  If  you become dizzy while using solvent, get fresh air immediately, and get medical aid. If contact with eyes is made, flush your eyes with water, and get medical aid immediately. Failure to observe these precautions could cause serious injury or death to personnel. Particles blown by compressed air are hazardous. Make certain the air stream is directed away from user and other personnel in the area. Compressed air used for cleaning purposes shall not exceed 30 psi (207 kPa). User must wear safety goggles or face shield to prevent injury. T A    2 4 2 5 9 9 2-388