TM 5-2815-241-34&P
ENGINE OIL COOLER REMOVAL
INITIAL SETUP
Tools
Personnel Required
Extension, 6-inch, 1/2-inch drive
Handle, ratchet, 1/2-inch drive
Socket, 9/16-inch, 1/2-inch drive
Socket, 3/4-inch, 1/2-inch drive
Wrench, box-end, 7/16-inch
Two
Equipment Condition
Water manifold removed (page 2-18).
ACTION
LOCATION
ITEM
REMARKS
1. Rear water header
cover (1)
Six screws (2) and
six lockwashers (3)
Using 7/16-inch box-end wrench, unscrew
and take out.
Discard lockwashers.
2. Right side of
cylinder block (4)
Rear water header
cover (1), gasket
(5), water transfer
tube (6), and two
packings (7)
Take off and pull out.
Discard gasket and packings.
3. Engine oil cooler
brace (8)
Screw (9), lock-
washer (10), and
flat washer (11)
Using 1/2-inch drive 3/4-inch socket,
6-inch extension, and ratchet handle,
unscrew and take out.
Discard lockwasher.
NOTE
When performing step 4, support oil filter shell to prevent it from falling,
4. Oil filter
shell (12)
Retaining screw (13)
Using 1/2-inch drive 9/16-inch socket and
ratchet handle, loosen.
Retaining screw remains attached to
oil filter shell.
5. Engine oil
cooler (14)
6. Oil filter
shell (12)
Oil filter
shell (12)
Lower and remove.
Oil filter cartridge
(15) and packing (16)
Take out.
Discard oil filter cartridge and
packing.
2-20
|
|
