TM 5-2815-241-34&P
IDLER PULLEY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
3. Idler pulley (5)
with attached parts
Sleeve spacer (6),
oil seal (7), and
preformed packing (8)
4.
5. Idler pulley (5)
6.
7. Bearing (13)
Shouldered shaft (9)
Retaining ring (10)
Screw (11) and
flat washer (12)
Shouldered shaft (9)
and bearing (13)
a.
Using 16-ounce ball-peen hammer and
1/2-inch cold chisel, drive bearing
spacer (6) off shouldered shaft (9).
b.
Take out oil seal and packing.
Discard.
Using snapring pliers, take off.
Using 5/32-inch hex wrench, unscrew and
take out.
Using bearing puller, pull out.
Using arbor press, press out.
CLEANING
NOTE
For general cleaning procedures, see General Maintenance Instructions, page 2-3.
T A 2 4 2 6 0 8
2-405
|
|
