TM 5-2815-24134&P
CROSSHEAD REMOVAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
1. Crosshead (1)
Locknut (2) and
adjusting screw (3)
Using 9/16-inch open-end wrench and
1/4-inch flat-tip screwdriver, loosen
locknut and unscrew adjusting screw two full
turns.
NOTE
Before performing step 2, tag crossheads, from front cylinder to rear cylinder, for
identification and location as shown in table below.
2. Cylinder heads (4)
Twelve cross-
heads (1)
Take off.
TASK ENDS HERE
TA 242355
2-32
|
|
