TM   5-2815-241-34&P GEAR  CASE  COVER  REMOVAL INITIAL  SETUP Tools Personnel   Required Extension,   6-inch,   1/2-inch   drive Handle,   ratchet,   1/2-inch   drive Socket,  7/16-inch,  12-point,  1/2- inch   drive Two Equipment   Condition Socket,   5/8-inch,   1/2-inch   drive Socket,   7/8-inch,   1/2-inch   drive Accessory  drive  removed  (page  2-43). Oil  pan  removed  (page  2-44). ACTION LOCATION ITEM REMARKS 1.  Gearcase  cover  (1) Six  screws  (2)  and six   lockwashers   (3) 2. Vibration  damper  and pulley  (4) 3. Two  screws  (5)  and two   lockwashers   (6) 4. 5. Six screws (7) six Using  1/2-inch  drive  5/8-inch  socket  and lockwashers   (8),   and ratchet  handle,  unscrew  and  take  off. engine  mount  (9) Discard  lockwashers. Thirteen   screws   (10) and  thirteen  lock- washers  (11) Using   1/2-inch   drive   5/8-inch   socket   and ratchet  handle,  unscrew  and  take  out. Discard    lockwashers. Using   1/2-inch   drive   7/8-inch   socket, 6-inch  extension,  and  ratchet  handle, unscrew  and  take  out. Discard    lockwashers. Take  off. Using   1/2-inch   drive   12-point,   7/16-inch socket  and  ratchet  handle,  unscrew  and take   out. Discard  lockwashers. WARNING Due to excessive weight, assistance will be needed to prevent personal injury when lifting heavy parts. 6.  Front  of  cylinder block  (12) Gearcase  cover  (1) and  gasket  (13) With  assistance,  take  off. Discard  gasket. 2-48