Fixed Equipment/Components - Removal/Installation

Custom Search

Back
Floor Insert Fasteners and Plugs - Inspect

Up
TM-55-4920-436-13-P Engine Shop P/N SC-4920-97-CL-A60 Manual

Next
Appendix A. REFERENCES

TM 55-4920-436-13&P

3-20. Fixed Equipment/Components - Removal/Installation

3-20

This task covers:

Removal/installation of fixed, equipment component

INITIAL SETUP

Tools:

Tool Kit, Powerplant, NSN 5180-00-323-4944

Personnel Required:

68B Aircraft Powerplant Repairer

REMOVAL/INSTALLATION

NOTE

Permanently installed equipment or components should not be removed, however, in the

event it becomes necessary to remove, reinstall or replace fixed equipment or shop

components within the shelter, care must be taken to remove all bolts, nuts and other

fasteners. All cabinets and racks are bolted to the floor and unless isolated, are normally

bolted to adjacent cabinets and/or to the wall and ceiling.

1. Remove bolts (1) nuts and washers (2).

2. During reinstallation of fixed equipment or components

the same hardware should be used so as to maintain the

original integrity of the shop sets. This is especially

critical in regard to items bolted to walls or ceilings.

END OF TASK

3-30