C H A P 5, SEC II
D I S A S S E M B L Y
P A R 74, STEPS 9 - 1 2
Figure 47 (Step 9)
Using a soft hammer, and while raising trans-
fer housing (A), tap lightly on the torque con-
v e r t e r a s s e m b l y ( B ) t o r e m o v e i t f r o m t he
h o u s i n g.
Figure 48 (Step 10)
U s i n g a l / 2 - i n c h w r e n c h , l o o s e n 2 4 t o r q ue
c o n v e r t e r c o v e r - t o - p u m p a s s e m b l y n u t s ( A ),
and remove all but two, 180 degrees apart.
8
0
Figure 49 (Step 11)
Turn the converter over and remove the two
remaining nuts. Using three 3/8-24 bolts (A)
as jacks crews, separate lockup clutch reaction
plate (B) from cover (C). Using sling (D) and
hooks (E), remove pump assembly (F).
Figure 50 (Step 12)
Remove torque converter stator assembly (A).
|
|
