TM 9-2520-272-34&P
4-14 INSTALL CONVERTER ELEMENT COMPONENTS
(SHEET 5 OF 7)
NOTE
Balance marks are used on the clutch lockup
plate and on the converter pump housing.
The clutch lockup plate must be mounted so
that these two balance marks are aligned as
shown at the right.
17 Using 5/8 inch socket, remove plug (19) from hole at
side of converter housing. Rotate converter pump
housing until balance mark is visible through hole.
Using marker, mark top edge of pump above balance
mark for reference.
18 Install clutch lockup plate (18) on turbine (15) and on
converter pump (4) studs so that balance marks are
aligned.
Go to Sheet 6
TM85403
Para. 4-14, Task 1
4-53
|
|
