TM 9-2520-272-34&P
4-15.
INSTALL LEFT END COVER ASSEMBLY
(SHEET 2 OF 11)
Install Sump Communication Tube
NOTE
Sump communication tube is not installed until after
bevel gear assembly has been installed.
1 Apply petrolatum to machined end (smaller end)
of sump communication tube (1).
2 Install sump communication tube (1), small end
first,
through
tube
bore
in
right
end
of
transmission center housing (2).
3 Looking through tube (1) sight tube bore in left
end of center housing (2). Push small end of
tube into left end bore.
4 Using plastic faced hammer, tap end of tube (1)
at right end until small end of tube is seated in
left end bore and large end of tube is flush at
right end bore.
Remove Fabricated Range Pack Retaining Fixture
5 Using
stand
rotary
control
handle,
turn
transmission to left end up.
NOTE
Retaining fixture was installed (paragraph 4-8 to
prevent range pack from shifting when transmission
was rotated.
6 Using socket, remove bolt (3) and washer (4)
from retaining fixture. Remove fixture.
Go to Sheet 3
Para. 4-15, Task 1
Change 2 4-57
|
|
