TM 9-2520-272-34&P
4-15.
INSTALL LEFT END COVER ASSEMBLY
(SHEET 7 OF 11)
9 Using socket, install left lifting bracket (8), angled
inward, and two 3/8-16 x 1-1/2 inch bolts (9) and
washers (10) on left end cover assembly (6). Do
not tighten bolts (9).
10
Using socket, loosely install two 3/8-16 x 1-1/4
inch bolts (11) and washers (12) in body of left
end cover (6).
11
Using socket, loosely install the 27 remaining
3/8-16 x 11/4 inch bolts (13) and washers (14)
around perimeter of left end cover (6).
12
Using plastic faced hammer, tap cover (6) to
seat cover against gasket on center housing.
13
Using torque wrench, tighten all bolts (8, 11, 13)
to 27-32 lb-ft (37-43 N•m).
NOTE
Output shaft drag check is performed after
transmission has been assembled. Refer to
paragraph 5-2.
End of Task 2
TASK 3. INSTALL OIL FILTER HEAD ASSEMBLY
COMMON TOOLS:
Extension, socket wrench, 1/2 inch square drive, 6
inch
Handle, socket wrench, 1/2 inch square drive
Socket, socket wrench, 1/2 inch square drive, 9/16
inch
Wrench, torque, 0-175 lb-ft
REPAIR PARTS:
Kit, fluid pressure filter (19207) 5703232
SUPPLIES:
Petrolatum (Item 14, Appendix C)
Rag, wiping (Item 15, Appendix C)
PRELIMINARY PROCEDURE: Left end cover assembly is installed. Refer to this paragraph,
TASK 2.
Go to Sheet 8
4-62 Change 2
Para. 4-15 Task 3
|
|
