TM 9-2520-272-34&P
4-19.
DISASSEMBLE RIGHT END COVER ASSEMBLY
(SHEET 13 OF 16)
TASK 7, REMOVE STEER GEARS
COMMON TOOLS:
Extension, socket wrench, 1/2 inch square drive, 10 inch
Hammer, hand, ball peen
Handle, socket wrench, 1/2 inch square drive
Punch, straight, round nose
Socket, socket wrench, 1/2 inch square drive, 9/16 inch
NOTE
It is not necessary to remove bearings during disassembly for inspection.
Refer to TM 9-214.
Bearings on under side of RH steer driven gear and range steer gear consist of
cages and inner races.
Outer races remain in right end cover housing.
Bearings and races remaining in the right end cover, after gears have been
removed in this task, require application of heat for removal. Refer to
paragraph 4-20 for removal of these bearings and races.
Remove RH Steer driven gear (1) and bearing (2) from
RH output shaft (3).
Inspect bearing (2) for serviceability. If bearing
requires replacement, remove bearing from gear (1)
using hammer and punch
Remove range steer gear (4) and bearing (5) from right
end cover (6).
Inspect bearing (5) for serviceability. If bearing
requires replacement, remove bearing from gear (4)
using hammer and punch.
Go to Sheet 14
4-108
Para. 4-19, Task 7
1
2
3
4
|
|