1
2
3
4
5
6
7
8
TM 9-2520-272-34&P
4-21.
ASSEMBLE RIGHT END COVER ASSEMBLY
(SHEET 6 OF 22)
Install
NOTE
Right end cover turned inside up.
Brake clutch backing plate is to be
installed with part number, surface
downward.
six spring retaining pins (1) in brake clutch
backing plate (a.
Using rubber bands, fix pins (1) in position on plate (2).
NOTE
Plate (2) may be wiggled as necessary to
move it down on pins (3, 4). Plate may be
tapped with plastic faced hammer near pins
to seat plate
Install plate (2) on brake reaction pins (3, 4) so that
recesses in edge of plate accommodate range steer
gear (5) and steer idler gear (6).
Using 9/16 inch socket, install four bolts (7) and
washers (8) on plate (2).
Using torque wrench, tighten bolts (7) to 36-43 lb-ft
(49-58 N•m).
Install seal ring (9) on inside edge of plate (2).
Install four short brake reaction pins (10) in holes in
plate (2).
Install six springs (11) on pins (1).
Go to Sheet 7
Para. 4-21, Task 3
4-131
|
|
