TM 9-2520-272-34&P
4-28.
DISASSEMBLE CENTER HOUSING
(SHEET 2 OF 19)
1 Using 5/8 inch socket, remove 15 bolts (1) and washers
(2) from left brake support (3).
NOTE
When left brake support (3) is removed, the
brake cam may come out of the brake
assembly with the support or it may remain
in the center housing.
2 Using two pry bars, pry under opposite ends of brake
support (3) and loosen support. Remove brake support
(3).
3 Position support (3) on wooden blocks as shown.
4 Using 7/16 inch socket, loosen two retainer bolts (4).
Using 1/2 inch socket, loosen three stationary cam
bolts (5). Loosen bolts (4, 5) until bolt heads are
approximately 1/4 inch (6-1/2 mm) out of holes in
support (3).
5 Using plastic faced hammer, tap bolt heads (4, 5) to
loosen retainer and stationary cam located under
support (3).
6 Using 7/16 inch socket, remove two bolts (4) and
washers (6) from support (3). Using 1/2 inch socket,
remove three bolts (5) and washers (7) from support (3).
Go to Sheet 3
Para. 4-28, Task 1
4-173
|
|
