TM 9-2520-272-34&P
4-28.
DISASSEMBLE CENTER HOUSING
35
36
(SHEET 6 OF 19)
Remove brake coolant seal (41).
Using 9/16 inch socket, remove five bolts (42) and
washers (43) which hold brake backing plate (44) to
center housing.
CAUTION
If pry bars are used in Step 37, use care to
not damage inner lip on backing plate (44).
37
38
Using two pry bars (if necessary), remove plate (44)
from large pins (45).
Remove six headless straight pins (46).
FOLLOW-ON PROCEDURE: Install left brake
assembly. Refer to paragraph 4-30.
End of Task 1
TASK 2. REMOVE LEFT STEER GEAR, LEFT STEER AND OUTPUT SUN GEAR,
LEFT OUTPUT SHAFT, AND OUTPUT PUMP DRIVE GEAR
TOOLS:
Drift pin, 18 inches minimum length
Hammer, hand, plastic faced
Puller, gear
Puller, mechanical bearing, inside jaws (slide hammer)
NOTE
Transmission is on maintenance stand, right end up.
PRELIMINARY PROCEDURE: Left brake assembly is removed. Refer to this procedure,
TASK 1.
Go to Sheet 7
Para. 4-28, Task 2
4-177
|
|
