TM 9-2520-272-34&P
4-28.
DISASSEMBLE
(SHEET 15 OF
CENTER HOUSING
19)
19
20
21
22
23
24
25
26
27
Remove front carrier assembly (20).
Remove thrust washer (21) from inside carrier
assembly (20).
Remove thrust washer (22) from underside of carrier
assembly (20) or from top of center carrier assembly
(23).
Using two screwdrivers, remove retaining ring (24)
that retains second clutch pack (25).
Remove second clutch pack (25) consisting of four
friction disks and five steel reaction disks.
Using two screwdrivers. remove retaininq ring (26)
that retains second clutch piston housing assembly (27).
Put front support assembly lifter tool J 24473 over
end of shouldered shaft (range input shaft) (28) and put
lower end of tool in groove below splined area of
center sun gear (29).
Using thumb screw on tool, tighten bottom of lifting
tool in groove.
Install S-hook in top of lifting tool.
Go to Sheet 16
4-186
Para. 4-28, Task 6
|
|
