TM 9-2520-272-34&P
4-29.
REPAIR CENTER HOUSING COMPONENTS
(SHEET 4 OF 31)
TASK 2. REPLACE INNER BRAKE ADJUSTING LINK PIN
NOTE
Do not remove inner brake adjusting link pin unless replacement is necessary.
COMMON TOOLS:
Gage, vernier caliper
Hammer, hand, ball peen
Punch center
Vise, soft jaw
REPAIR PARTS:
Pin, spring (24617) 455675
SUPPLIES:
Rag, wiping (Item 15, Appendix C)
PRELIMINARY PROCEDURE: Inner brake adjusting link is removed. Refer to paragraph
4-28.
Remove Pin
1 Place inner brake adjusting link (1) in vise.
2 (Using hammer and punch, drive pin (2) from link (1).
Install Pin
3 Using hammer and punch, install new pin (2) to a
height of 0.118- 0.138 inch (3.00-3.50 mm) above
surface of link (1).
4 Remove link (1) from vise.
FOLLOW-ON PROCEDURE: Install inner brake
adjusting link.
Refer to paragraph 4-30.
End of Task 2
Go to Sheet 5
4-194
Para. 4-29, Task 2
|
|
