TM 9-2520-272-34&P
4-29.
REPAIR CENTER HOUSING COMPONENTS
(SHEET 18 OF 31)
TASK 7. REPLACE RANGE INPUT SHAFT COMPONENTS
COMMON TOOLS:
Drift, brass
Hammer, hand, ball peen
Hammer, hand, plastic faced
Pliers, retaining ring, external
Plier, wrench
Press, arbor, hand operated
Screwdriver, flat tip (2 required
SUPPLIES:
Petrolatum (Item 14, Appendix C)
Rag, wiping (Item 15, Appendix C)
PRELIMINARY PROCEDURE: Input shaft components
are removed. Refer to paragraph 4-28.
Disassemble Input Shaft Components
1
2
3
4
5
6
7
8
Remove two seal rings (1) from shouldered shaft
(range input shaft) (2).
Using screwdriver, remove retaining ring (3).
Remove front internal gear (4) from range input shaft
(2).
Remove range input shaft (2) with its attached parts
from rear carrier drum (5).
Remove center carrier (6) from input shaft (2).
Using retaining ring plier, remove retaining ring (7)
that holds spur gear (rear sun gear) (8) onto range
input shaft (2).
Remove rear sun gear (8) and attached parts from
range input shaft (2).
Using retaining ring pliers, remove retaining ring (9)
that holds rear sun gear (8) to internal gear (center
carrier ring gear) (10).
Go to Sheet 19
4-208
Para. 4-29, Task 7
|
|
