TM 9-2520-272-34&P
4-29.
REPAIR CENTER HOUSING COMPONENTS
(SHEET 20 OF 31)
NOTE
Do not remove pin (20) and bearing (21)
unless replacement is necessary.
16 Using wrench pliers, remove pin (20) from shaft (16).
17 Using arbor press, press bearing (21) from shaft (16).
Assemble Input Shaft Components
18
19
20
21
22
23
Go
Using arbor press, install bearing (21) to a seat against
the shoulder of shaft (16).
Using arbor press, install pin (20) to a height of
1.92-1.96 inch (48.8-49.7 mm) above surface of shaft
(16), measured from opposite side of shaft.
Install rear carrier assembly (18) onto shaft (16).
NOTE
Opening of retaining ring (19) must be
rotated so that it is between gears of rear
carrier assembly (18).
Using retaining ring pliers, install retaining ring (19)
that holds shaft (16) to rear carrier assembly (18).
Install drum (5) onto carrier (18).
Using screwdriver, install retaining ring (17) to hold
drum (5) onto carrier (18).
to Sheet 21
4-210
Para. 4-29, Task 7
|
|
