TM 9-2520-272-34&P
4-30. ASSEMBLE CENTER HOUSING
(SHEET 14 OF 20
NOTE
Leave hoist hooked to hydrostat so that you
can raise and turn hydrostat as necessary to
align bolt holes.
8 Using socket, install six bolts (10) and washers (11) in
hydrostat (2).
9 Remove hoist, S-hook, and eyebolt from hydrostat (2).
10 Using torque wrench and adapter, tighten six bolts (10)
to 36-43 Ib-ft (49-69 N•m).
FOLLOW-UN PROCEDURE: Install steer control
assembly. Refer to this paragraph TASK 5.
End of Task 4
TASK 5. INSTALL STEER CONTROL ASSEMBLY
COMMON TOOLS:
Adapter, socket wrench, 1/2 inch to 3/8 inch square drive
Extension, socket wrench, 3/8 inch square drive, 6 inch
Handle, socket wrench 3/8 inch square drive
Socket, socket wrench, 3/8 inch square drive, 1/2 inch
Socket Head Screw Attachment, socket wrench, 3/8 inch square drive, 3/8 inch hex plug end
Wrench torque, 0-175 ft-lb
Wrench torque, 0-600 in-lb
SUPPLIES:
Sealant, lubricating, thread-locking (Item 16, Appendix C)
PRELIMINARY PROCEDURE: Hydrostat is installed. Refer to this paragraph TASK 4.
Go to Sheet 15
Para. 4-30, Task 5
4-235
|
|
