TM 9-2520-272-34&P 4-5. REMOVE TRANSMISSION TOP COMPONENTS (SHEET 3 OF 8) TASK 2.  REMOVE WIRING HARNESS ASSEMBLY COMMON TOOLS: Handle, socket wrench, 1/2 inch square drive Extension, socket wrench, 1/2 inch square drive, 6 inch Screwdriver, cross-tip, No.  1 tip Screwdriver, flat tip Socket, socket wrench, 1/2 inch square drive, 1/2 inch SUPPLIES: Cloth, lint-free (Item 6, Appendix C) Twine, cotton, 16 ply, 30 inches (Item 21, Appendix C) NOTE • cover assembly is removed from transmission. • harness can be removed without removal of solenoids or control valve assemblies. • harness does not have to be removed to remove control valve assemblies. 1 Clean   wiring   harness   connector   body   (1)   and transmission area around connector. 2 Using  cross-tip  screwdriver,  remove  four  screws (2)    holding    harness    connector    body    (1)    to transmission. 3 Using  flat  tip  screwdriver,  unfasten  seven  plastic connectors (3) that attach harness (4) to solenoids (5). 4 Using   socket,   remove   bolt   (6)   and   washer   (7) holding   harness   ground   connector   (8)   to   main control valve assembly (9). Go to Sheet 4 Para.  4-5, Task 2 Change 2  4-7