TM 9-2520-272-34&P 4-7.  REMOVE RIGHT END COVER ASSEMBLY (SHEET 6 OF 7) Remove Inner Steer  Shaft,  Range  Output  Gear  Spacer, Tubes NOTE It may be necessary to wiggle steer shaft to remove it from transmission. 9. Remove inner steer shaft (10) 10. Using    retaining    ring    pliers,    remove    retaining rings (11) round, bent, or if tension is lost. 11 Remove range output gear spacer (12) 12 Remove lube tube (13)    and two packings (14). 13. packings (14) NOTE Brake   apply   tube   (15)   may   remain   in right   end   cover   assembly,   or   it   may remain in center housing. On    X200-4    Brake    apply    tube    and    2 packings  are  loose  between  Right  End Cover and Center Housing. On X200-4A Brake apply tube is pressed  into  Right  Hand  Brake  support and uses only 1 Packing. 14. Remove brake apply tube (15) and two packings (16). 15. Remove packings (16) 16. Remove    brake    coolant    tube    (17)    and    two packings (18). 17. Remove packings (18) NOTE On  X200-4A  remove  one  packing  (18) from   tube   (17)   which   is   pressed   into Right Hand Brake support. 19. Using slip-joint pliers, remove sump communication tube (19) NOTE If tube (19) does not lift out easily, leave it in place. Para.  4-7, Task 2 Change 2  4-25