ARMY TM 9-2805-256-14
AIR FORCE TO 38G2-102-2
NAVY NAVFAC P-8-611-14E
4 - 3 0 . B r e a k e r P o i n t s ( B r e a k e r P o i n t I g n i t i o n ) .
This task covers:
Adjustment
INITIAL SETUP
Tools
Materials/Pads
General Mechanic’s Tool Kit (Item 1, Appendix B)
Engine Oil (Item 2, Appendix D)
A d j u s t m e n t . (figure 4-21)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
4 - 46
Unsnap two clips (1) securing breaker point cover (2) and move cover out of way.
Remove screw (3) and washer (4).
Loosen screw (5) and move connector bar (6) out of way.
Rotate engine by hand until cam follower (7) is on highest point of ignition cam (8).
Loosen screw (9) and adjust point gap to .016 to .020 in. (.040 to .050 cm), and tighten screw (9)
Recheck point gap and adjust as necessary.
Using clean engine oil, lubricate cam wick (10) sparingly.
Position connector bar (6) and secure with screw (3) and washer (4).
Tighten screw (5).
Install breaker point cover (2) and secure with two clips (1).
|
|
