ARMY TM 9-2805-257-14 AIR FORCE TO 38G2-103-2 NAVY NAVFAC P-8-612-14E 5-13. Low Voltage Cable (Breakerless Ignition). This  task  covers: a.  Removal b.  Installation INITIAL  SETUP Tools Equipment   Condition General  Mechanic’s  Tool  Kit  (Item  1,  Appendix  B) Flywheel  Removed  (para.  4-38) a. Removal.  (figure  5-10) WARNING Use extreme care when removing coil clamps. Flying clamps can cause serious eye injury. Cover work area with rag or hand when removing clamps. NOTE (1) (2) (3) (4) Before removing coil observe placement of coil leads. Remove two coil clamps (1) and move coil (2) slightly, tag and disconnect coil leads and remove coil (2). Disconnect low voltage cable (3) from ignition control unit (4). Remove two clamps (5), cable nut (6) and washer (7) and pull low voltage cable lead (8) through bearing cap (9). Loosen connector nut (10) and remove low voltage cable (3). b. Installation.  (figure 5-10) (1) (2) (3) (4) (5) 5-24 Install low voltage cable (3) and tighten connector nut (10). Route low voltage cable lead (8) through bearing cap (9) and install washer (7) and cable nut (6) and tighten  cable  nut  (6). Install two clamps (5) on low voltage cable lead (8). Connect low voltage cable (3) to ignition control unit (4). Connect coil leads as tagged, and install coil (2) and secure with two coil clamps (1).