ARMY TM 9-2805-257-14 AIR FORCE TO 38G2-103-2 NAVY NAVFAC P-8-612-14E 4-27. Governor Assembly. This task covers: Adjustment INITIAL SETUP Tools Materials/Parts (cont) General Mechanic’s Tool Kit (Item 1, Appendix B) Gasket, Throttle Housing to Carburetor (P/N 9786E65-4) Materials/Parts Gasket, Throttle Housing Rear (PIN 9786E65-3) Gasket, Throttle Housing Front (P/N 9786E64-6) Rags, Wiping (Item 6, Appendix D) Solvent, Drycleaning (Item 7, Appendix D) a. Adjustment.  (figure 4-19) (1) Remove two screws (1) and washers (2) securing throttle housing cover (3) and remove cover and gasket (4). (2) Remove screw (5) and washer (6) securing throttle lever (7) to carburetor throttle rod (8) and remove lever from rod. (3) Loosen clamp (9) on governor control rod housing (10) and remove control rod housing (10) from throttle housing (11). (4) Remove two screws (12) and washers (13) securing throttle housing (11) to carburetor (14) and remove throttle housing (11 ), gasket (15) rear cover (16), and gasket (17). (5) Hold carburetor throttle (18) 1/16 infrom the open position, loosen lock nut (19) on control rod (20), and adjust clevis (21) until throttle lever (7) fits onto carburetor throttle rod (8). (6) Tighten lock nut (19). (7) Install gasket (17), rear cover (16), gasket (15), throttle housing (11) and secure using two screws (12) and washers (13). (8) Install governor control rod housing (10) on throttle housing (11) and secure with clamp (9). (9) Install throttle lever (7) on carburetor throttle rod (8) and secure with screw (5) and washer (6). (10) Install throttle housing cover (3) and gasket (4) on throttle housing (11) and secure with two screws (1) and washers (2). (11) Start engine (para2-9). 4-44 Change 2