ARMY TM 9-2805-257-14 AIR  FORCE  TO  38G2-103-2 NAVY NAVFAC P-8-612-14E 4-30.  Breaker   Points   (Breaker   Point   Ignition). This  task  covers: Adjustment INITIAL  SETUP Tools Materials/Parts General  Mechanic’s  Tool  Kit  (item  1,  Appendix  B) Rags, Wiping (Item 6, Appendix D) Oil,  Engine  15W-40  (Item  2,  Appendix  D) Adjustment.    (figure   4-21 (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) 4-50 Unsnap two clips (1) securing breaker point cover (2) and move cover out of way. Rotate engine by hand until cam follower (3) is on highest point of ignition cam (4). Loosen  screw  (5). Remove screw (6) and washer (7) and move connector bar (8) out of way. Loosen screw (9) and adjust point gap to 0.16 to .020 in. (0.40 to 0.50 cm), and tighten screw (9). Recheck point gap and adjust as necessary. Position connector bar (8) and secure with screw (6) and washer (7). Tighten  screw  (5). Use clean engine oil and lubricate cam wick (10) sparingly. Install breaker point cover (2) and secure with two clips (1).