ARMY TM 9-2805-258-14
AIR FORCE TO 38G2-89-21
NAVY NAVFAC P-8-614-14E
4-42. Governor Control Rod.
This task covers:
a. Adjustment
b. Removal
c. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanic’s Tool Kit (Item 1, Appendix B)
Top cover removed (para. 4-21).
a.
Adjustment. (figure 4-36)
(1) Remove screw (1) and washer (2) and remove governor control rod (3) from governor arm (4).
(2) Loosen lock nut (5).
(3) Ensure governor control (6) is at full throttle position.
N O T E
If adjustment cannot be obtained on one end, utilize the other end.
(4) Push governor control rod (3) to full throttle position and adjust length as follows:
(a) For engines equipped with Tillotson carburetor, adjust rod length so that hole in ball joint (7) alines
with mounting hole in governor arm (4).
(b) For engines equipped with Bendix carburetor adjust length so that hole in ball joint (7) is
approximately 1/2 in. (1.27 cm) from mounting hole in generator arm (4).
(5) Tighten lock nut (5).
(6) Install governor control rod (3) and secure with screw (1) and washer (2).
4 - 78
|
|
