ARMY TM 9-2805-258-14
AIR FORCE TO 38G2-89-21
NAVY NAVFAC P-8-614-14E
4-47. Carburetor (cont).
b. R e m o v a l . ( f i g u r e 4 - 4 4 )
(1) Remove screw (1) and washer (2) and remove governor control rod (3).
W A R N I NG
Do not smoke or use open flame in the vicinity of gasoline vapors.
(2) Loosen fitting nut (4) on fuel line (5).
(3) Loosen screw (6) and remove choke assembly (7) from choke rod (8).
(4) Remove screw (9), washer (10), and nut (11) securing manual choke clamp (12).
(5) Remove manual choke (13) and spring (14) from choke lever (15).
(6) Remove two nuts
( 2 0 ).
16), Iockwashers (17) and flat washers (18) and remove carburetor (19) and gasket
W A R N I N G
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100°F.-138°F, (38°C.-6O°C.).
(7) Clean outside of carburetor (19) with drycleaning solvent and dry thoroughly.
(8) Inspect carburetor (19) and replace if carburetor body is cracked or otherwise damaged.
c.
Installation.
(figure 4-44)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
4 - 94
Ensure all gasket mating surfaces are clean and free of old gasket material.
Install carburetor (19) and gasket (20) and secure with two nuts (16), Iockwashers (17), and flat
washers (18).
Install spring (14) and manual choke (13).
Install manual choke clamp (12) and secure with screw (9) and washer (10) and nut (11).
Install fuel line (5) and tighten fitting nut (4).
Position choke lever (15) in the full open position and install choke assembly (7) in horizontal position
and tighten screw (6).
Install governor control rod (3) and secure with screw (1) and washer (2).
|
|
