ARMY   TM   9-2805-262-14 AIR  FORCE  TO  38G2-90-1 NAVY  NAVFAC  P-8-613-14E 4-47.  Coil   Cover. This  task  covers: a. Removal (breaker point ignition) d.  Removal  (breakerless  ignition) b. Inspection (breaker point ignition) e.  Installation  (breakerless  ignition) c.  Installation  (breaker  point  ignition) INITIAL  SETUP Tools Equipment   Condition General  Mechanic’s  Tool  Kit  (Item  1,  Appendix  B) Breaker  point  cover  removed  on  engines  equipped  with breakerless  ignition  (para.  4-44). Materials/Parts Starter  rope  pulley  removed  (para.  4-43). Gasket,  Coil  Cover  Mounting  (NSN  5330-00-867-8795) a. Removal (Breaker Point Ignition). (figure 4-46) (1) (2) (3) (4) (5) (6) (7) (8) (9) Loosen connector nut (1) and tag and remove high tension cable (2). Repeat  step  1  for  remaining  high  tension  cables. Remove  nut  (3)  and  washer  (4)  and  tag  and  remove  electrical  lead  (5)  from  noise  suppression  filter  (6). Repeat  step  3  for  remaining  noise  suppression  filter. Remove screw (7) and washer (8) securing cable clamp (9) and move out of way. Repeat  step  5  for  remaining  cable  clamp. Remove  two  screws  (10),  washers  (11),  securing  coil  cover  (12),  and  gasket  (13). Remove nut (14) and washer (15) securing coil lead (16) to noise suppression filter (6) and tag and remove  lead. Repeat  step  8  for  remaining  noise  suppression  filter,  remove  coil  cover  (12),  and  gasket  (13). b. Inspection.  (figure 4-46) c. Installation  (Breaker  Point  Ignition). (figure 4-46) (1) (2) (3) 4-94 Connect coil lead (16) as tagged to noise suppression filter (6) and secure with nut (14) and washer (15). Repeat  step  1  for  remaining  noise  suppression  filter. Install coil cover (12) and new gasket (13) and secure with two screws (10) and washers (11).