|
ARMY TM 9-2805-262-14
AIR FORCE TO 38G2-90-1
NAVY NAVFAC P-6-613-14E
5-7.
d.
Cylinder Head Assembly (cont).
Installtion. (figure 5-4).
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
5-12
Ensure all gasket surfaces are clean, and old gasket material is removed.
Install preformed packings (13), pushrod tubes (12), and push rods(11).
Install cylinder head (9) and gasket (10) and secure with four nuts (7) and washers (8). Toque nuts to
22-24 ft lb (47151-51437 gr cm).
Install drain tube (5) and finger tighten compression nut (6).
Connect drain tube (5) to cylinder head (9) and tighten coupling nut (4), and finish tightening
compression nut (6).
Position rockers (3) on push rods(11) and tighten adjusting screws (2) until rockers are snug.
Adjust valves.
Repeat steps 1 thru 7 for remaining cylinder heads.
|
|
