ARMY TM 9-2805-262-14
AIR FORCE TO 38G2–90-1
NAVY NAVFAC P-8-613-14E
5-I6. Low Voltage Cable (Breakerless Ignition).
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
General Mechanic’s Tool Kit (Item 1, Appendix B)
a. Removal. (figure 5-13)
(1)
(2)
(3)
(4)
NOTE
There are five screws securing cover on left hand side of engine.
Remove four screws (1) and remove ignition control unit cover (2) and gasket (3).
Tag and remove low voltage cable leads from ignition control unit (4). Refer to figure 5-26 for wiring
diagram.
Loosen connector nut (5) and remove low voltage cable (6) from ignition control unit (4).
Loosen connector (7) and remove low voltage cable from junction box (8).
b.
Installation. (figure 5-13)
(1) Connect low voltage cable (6) to junction box (8) and tighten connector (7).
(2) Connect low voltage cable (6) to ignition control unit (4) and tighten connector nut (5),
(3) Connect low voltage cable leads as tagged.
(4) Install cover (2) and gasket (3) and secure with four screws (1).
5-30
|
|
