ARMY TM 9-2805-262-14
AIR FORCE TO 38G2-90-1
NAVY NAVFAC P-8-613-14E
5-17. Coil.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Condition
General Mechanic’s Tool Kit (Item 1, Appendix B)
Coil cover removed (para. 4-47)
a. Removal. (figure 5-14)
WARNING
Flying coil clamps can cause serious eye injury. Cover work area with hand or rag when
removing coil clamps.
(1) Remove two coil clamps (l), make note of coil orientation, and remove coil (2).
(2) Repeat step (1) for remaining coil.
b.
Installation. (figure 5-14).
NOTE
If the engine is equipped with Teledyne-Brown breakerless ignition, the right hand coil
must be installed with TOP reference designation pointed down, and the yellow lead
connected to no. 5 terminal and red lead connected to no. 6 terminal in the left hand
ignition control unit. If the engine is equipped with Cott Industries breakeriess ignition, the
engine can be setup in the configuration above or with the right hand coil with the TOP
reference designation up, and yellow lead connected to no. 6 terminal and red lead
connected to no. 5 terminal.
(1) Install coil (2) in the same orientation as removed and secure with two coil clamps (1).
(2) Repeat step 1 for remaining coil.
5 - 3 2
|
|
