ARMY  TM  9-2805-262-14 AIR  FORCE  TO  38G2-90-1 NAVY  NAVFAC  P-8-613-14E 5-18.  Oil   Pump   Cover. This  task  covers: a. Removal b.  Inspection c.   Installation INITIAL  SETUP Tools Equipment   Condition General  Mechanic’s  Tool  Kit  (Item  1,  Appendix  B) Breaker  point  cover  removed  (para.  4-44). Condensers  removed  (para.  4-46). Materials/Parts Breaker  points  removed  (para.  4-49). Rags, Wiping (Item  7, Appendix  D) Solvent,  Drycleaning  (Item  8,  Appendix  D) Gasket, 0il Pump Housing Mounting (P/N   13206E0326) a. Removal. (figure 5-15) NOTE Step 1 is for engines with breakerless ignition. (1) Remove screw (1) and washer (2) securing loop clamp (3) and remove lead (4). (2) Remove eight screws (5) and washers (6) and remove oil pump cover (7) and gasket (8). b. Inspection. WARNING Drycleaning  solvent  PD-660  used  to  clean  parts  is  potentially  dangerous  to  personnel  and property. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. Flash point of solvent is 100°F-138°F (38°C-60°C). (1) Clean oil pump cover with drycleaning solvent, and dry thoroughly. (2) Inspect oil pump cover and replace if cracked or otherwise damaged. 5-34