| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
FLYWHEEL AND ADAPTER REPLACEMENT (2DR)
0103 00
REMOVAL (Continued)
NOTE
Early model engines had lock plates securing the adapter fasteners.
Remove and discard the lock plates. Lock plates are not used upon
reinstallation; instead, increase the torque of the fastener to
1300-1350 inch-pounds (146.8-152.5 Nm).
6. Remove adapter (9)
a. Use engine turning tool (3) to prevent PTO shaft (2) from turning.
b. Remove screws (10) securing adapter (9) to crankshaft (11).
c. Install three of the removed screws (10) into the threaded puller holes of adapter (9).
d. Alternately tighten screws (10) to pull adapter (9) from dowel pins (12) in crankshaft (11).
2
9
11
10
3
12
CLEANING
1. See Work Package 0028 for General Cleaning Procedures.
INSPECTION
All parts must be inspected with care. Replace parts if damage or wear exceeds allowable
limits.
1. See Work Package 0028 for General Inspection Procedures.
WP 0103 00-4
|
||
|
||
