| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
ACCESSORY DRIVE HOUSING REPLACE/REPAIR
0158 00
ASSEMBLY
1. Install new needle roller bearing (39) (item 305, WP 0175), retaining ring (38) (item 280,
2. Install recessed washer (35), and new bearing (36) (item 292, WP 0175) into housing (8).
3. Install spur gear shaft (34) into housing (8).
4. Install three new pipe plugs (32) (item 77, WP 0175) and one pipe plug (33) (item 77,
5. Apply a thin coat of gasket cement (item 21, WP 0173) on mating surface of housing (9).
NOTE
Top two studs between housings (8 and 9) do not receive nuts and
washers at this time so as to allow for attachment of the accessory
drive sling.
6. Assemble housing (9) to housing (8).
a. Fasten housings together using seven new self-locking nuts (6) (item 33, WP 0175) with
flat washers (7).
7. Install fuel injection pump flexible shaft coupling (31). Refer to WP 0115 for special tools and
installation procedure.
32
32
8
37
32
7
6
38
39
9
36
31
35
34
33
WP 0158 00-15
|
||
|
||
