| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
FUEL INJECTION ADVANCE CONTROL TEST
0162 00
TEST
1. Turn motor switch (7) "ON".
2. Push jog/run switch (6) and turn speed regulator control (8) clockwise to obtain a speed of
300 rpm as indicated on tachometer (26).
3. Observe oil pressure indicator gauge (27) and fuel pressure indicator gauge (28).
CAUTION
Turn master switch handle "OFF" if there is no indication of oil or
fuel pressure on the gauges. Investigate and correct the deficiency
before continuing test. Failure to comply may result in damage to
equipment.
a. Both gauges should register more than zero (0); however, maximum pressures will not be
evident until a speed of 2000 rpm is obtained.
4. Operate test stand at 300 rpm until the oil temperature dial (29) stabilizes at 200 F (93.33 C).
a. It may require several minutes of running at 300 rpm to warm the entire system to
operating temperature.
29
28 27
26
8
6
7
WP 0162 00-8
|
||
|
||
