| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
FUEL INJECTION ADVANCE CONTROL TEST
0162 00
ADJUSTMENT PROCEDURE (Continued)
2. Remove and discard two cotter pins (33) and loosen slotted nuts (34) enough to permit
adjusting ring (32) to rotate.
3. Make adjustment.
a. Move the adjusting ring (32) 1/16 inch (1.5875 mm) toward the rear of test stand (retard
position) if the advance unit advanced too soon.
b. Move the adjusting ring (32) 1/16-inch (1.5875 mm) in the opposite direction (advance
position) toward the operator if the advance unit advanced too late.
4. Tighten two slotted nuts (34) to 110-150 inch-pounds (12-17 Nm).
5. Repeat "Before Test" steps 2 and 8.
6. Repeat "Test".
a. When advance readings are within the prescribed limits, install two new cotter pins (33)
(item 47, WP 0175) go to "After Test."
34
32
33
34
WP 0162 00-14
|
||
|
||
