TM 9-2815-226-34-1
(23) Remove Rocker Lever Housing.
(a) Mark housing positions (No. 1, 2, and 3, from front to rear).
(b) Loosen valve adjusting screw locknuts and injector adjusting screw locknuts an d back out, turning to left
until tension is released.
NOTE
If aluminum rocker housing is used, special steel washers are used with housing
hold-down studs. If steel rocker housing is used, no washers are installed. Note
various lengths and locations of hold-down studs to ensure proper reassembly.
Three different lengths are used.
(c) Remove hold-down studs and washers (if used) securing housings to cylinder heads.
(d) Lift and remove housings and gaskets. Discard gaskets.
Change 1 3-37