| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-1
WARNING
HOT TANK CLEANING SOLVENTS ARE POTENTIALLY DANGEROUS. WEAR
PROTECTIVE CLOTHING AND GOGGLES TO PREVENT SERIOUS PERSONAL
INJURY.
i. Submerge cylinder block in hot agitation tank with water and cleaning solvent solution heated to 180F-200F
(82C-93C). Leave in tank for 12 hours.
j. Remove block from hot tank and steam clean to remove loose sludge and deposits.
k. Run rods with brushes or swabs through all pas sages.
WARNING
COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI
(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONAL
PROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).
l. Blow shop air through all passages, ports, and capscrew holes to remove debris.
m. Direct shop air through no. 1 cylinder air vent hole which opens to water pump cavity.
n. With emery cloth, remove any nicks and burrs from liner upper and lower counterbores.
3-59
|
||
|
||
