| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-1
(21) Aline sleeve in top of water hole and carefully tap in sleeve with driver until it bottoms.
NOTE
Salvage sleeve will protrude above surface of head.
(22) With flat mill file, carefully file sleeve flush with head surface. If proper sleeve is not available, heavy walled
7/16 in. (11.112 mm) inside diameter copper tubing may be used. Tuoing must provide 0.002 to 0.005 in.
(0.050 to 0.127 mm) press fit. Overall length should be approximately 1/2 in. (12.70 mm).
WARNING
COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI
(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONAL
PROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC).
(23) Thoroughly clean water passages with compressed air to remove cuttings and filings.
3-174
|
||
|
||
