| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-1
WARNING
COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI
(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONAL
PROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).
P-D-680 SOLVENT IS POTENTIALLY DANGEROUS. AVOID PROLONGED OR
REPEATED CONTACT WITH SKIN. KEEP AWAY FROM FLAME OR EXCESSIVE
HEAT.
(2) Clean insert bore with solvent and dry with compressed air.
CAUTION
USE NEW PUSH TUBE ANYTIME INSERT IS REPLACED.
THIS PRACTICE
ENSURES PROPER VALVE AND INJECTOR PERFORMANCE.
(3) Carefully press new insert into follower lever.
(4) Check insert to ensure it is fully seated.
c. Repair cam follower housing.
NOTE
Repair limited to removal of sharp edges, nicks, and burrs at shaft entry points.
(1) Place small strip of 240 grit aluminum oxide sanding cloth on steel rod, split to accept paper.
(2) Clean bore with sanding cloth and rod secured to hand drill.
WARNING
COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI
(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONAL
PROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).
P-D-680 SOLVENT IS POTENTIALLY DANGEROUS.
AVOID PROLONGED OR
REPEATED CONTACT WITH SKIN. KEEP AWAY FROM FLAME OR EXCESSIVE
HEAT.
(3) Dip housing in solvent and dry with compressed air.
3-221
|
||
|
||
