| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-2
(10) While holding injector plunger link, open hydraulic valve to raise hydraulic actuator raising injector to
clamped position.
(11) Close hydraulic valve to lock injector in clamped position.
(12) Remove standard knurled knob from test stand inlet connector and install ST-708 burnishing tool through
connector and into injector adapter pot inlet port. Retract burnishing needle by pulling out small needle
shaft knob.
(13) Secure drain connection (clear line) to injector adapter pot.
3-279
|
||
|
||
