| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-2
(2)
Continue rotating to 90 degrees ATDC. In this position, two dash marks on camshaft gear are in
position to aline with accessory drive gear center-punch mark when drive is installed.
(3)
Place new gasket on cylinder block accessory drive mounting pad.
(4)
Install accessory drive, alining center-punch mark on accessory drive gear with camshaft timing
dash marks.
(5)
Secure drive with lockwashers and capscrews.
(6)
Screw stud into threaded hole in block above accessory drive gear.
3-433
|
||
|
||
