| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-2
ay.
Install alcohol evaporator (TM 9-2320-281-20).
az.
Install alternator (TM 9-2320-281-20).
ba.
Install starter (TM 9-2320-281-20).
bb.
Install fan clutch assembly and drive belts (TM 9-2320-281-20).
bc.
Install power steering cooler (TM 9-2320-281-20).
bd.
Install starter relay mount bracket (TM 9-2320-281-20).
CAUTION
DO NOT INSTALL POWER STEERING PUMP IF ENGINE IS TO BE TESTED ON
DYNAMOMETER. PUMP FAILURE WILL OCCUR IF PUMP OPERATED WITHOUT
HYDRAULIC FLUID.
be.
Install cover plate on engine oil pump (if power steering pump not to be installed).
bf.
Install power steering pump if engine not to be tested on dynamometer (TM 9-2320-281-20).
Section XXXII. ENGINE TESTING
3-95. TEST ENGINE ASSEMBLY
NOTE
Break-in and testing are accomplished simultaneously. Break-in of new or rebuilt
engine is necessary because it provides an operating period during which moving
parts acquire their final finish and mating surfaces reach a full seat. Engine testing
helps detect possible assembly errors, need for adjustments as engine "breaks-
in," and establishes a period for final adjustments for best engine performance.
a.
Install engine on dynamometer.
(1)
Place engine on dynamometer test stand.
(2)
Secure engine mount pads to engine support risers.
(3)
Position dynamometer drive shaft flange to engine flywheel. Check for proper alinement as per
manufacturer's instructions.
3-462 Change 1
|
||
|
||
