TM 9-2815-237-34 2-35.3.   (6.2L or 6.5L)  FUEL INJECTION PUMPS (DB2829-4523, DB2829-4879, or DB2831-5149) CALIBRATION USING FUEL INJECTION PUMP TEST STAND (FTIS) MODEL A8022 (Cont’d) 7. Install test adapter and connector on fuel inlet port (2) of fuel injection pump (1). 8. Connect one end of hose assembly to connector and insert other hose end into calibration fluid supply quick-connect on front panel of test stand (3). 9. Remove screw (8), tab (7), washer (6), and O-ring (5) from fuel injection pump transfer port (4). 10. Position test adapter on fuel injection pump transfer test port (4) and secure into position with existing O-ring (5), tab (7), and washer (6) removed in step 9. 11. Install quick-connect plug into test adapter. 12. Connect one end of rubber hose assembly (9) to quick-connect plug and other hose assembly end to auxiliary pressure quick-connect on front panel of test stand (3). 13. Install male pipe fitting on fuel injection pump (1). 14. Connect one end of tubing to male pipe fitting on fuel injection pump (1) and other end to calibration fluid push-on connector on front panel of test stand (3). CAUTION When installing high-pressure delivery lines on fuel injection pump, use two wrenches to prevent damage to discharge fittings. 15. Install eight high-pressure delivery lines on discharge fittings (10) of fuel injection pump (1). 2-140.14          Change 1 TUBING MALE PIPE FITTING TEST ADAPTER CONNECTOR HOSE ASSEMBLY PUSH-ON CONNECTOR 1 2 3 QUICK- CONNECT